€12.82 tax excl.
Secure payment
Secure payment by bank card, PayPal, cheque or bank transfer
Shipped within 48 hours (excluding vehicles)
Contact us for shipping glass parts (windscreens or windows)
Customer service available from 9am to 5pm
16 other products in the same category:
Synchro ring - grooved type for early gearboxes, to fit 750, 101, 102, 106 (2600) and early 105 series gearboxes.
Rubber plug for gearbox bellhousing. We understand this is only fitted to some 750 cars.
Mainshaft front bearing to fit 105 series mechanical clutch cars. Also fits 101 series, late 102 series and all 2600s (106 series). Inside diameter 30 mm, outside diameter 62 mm, width 23.8 mm.
Speedometer cable for all right-hand drive 105 series cars. 2.0 m long, it will also fit 750 and 101 series cars if required.
Gear change detent ball on 101, 105, 116 and 75 models.
Rear gearbox oil seal for all 105 series gearboxes, both mechanical/cable and hydraulic clutch cars, as well as 101 and 106 series gearboxes.
Input shaft needle roller bearing to fit all 101/105 gearboxes. Also fits late 102 series and all 2600s (106 series). Inside diameter 20 mm, OD 26 mm, width 17 mm.
Rev counter/tacho cable for left-hand drive 105 series cars. At 1.55 m long, it will also fit some 750 and 101 series cars.
Mainshaft rear bearing to fit mechanical clutch cars. Inside diameter 25 mm, outside diameter 52 mm, width 15 mm.
Layshaft intermediate bearing for 101 and 105 series gearboxes Also fits late 102 series and all 2600s (106 series).
Gearbox rear mounting bush (48 mm diameter) to fit the 750 and early 101 four-speed gearbox.
Tab washer to fit the rear of the gearbox mainshaft on all 101 series 5-speed gearboxes and 105 series 5-speed boxes up to approximately 1972. Due to gearbox interchangeability, you may find this...
1.85M long. Used as the speedometer cable on LHD cars and as the rev counter/tacho cable on RHD cars. Fits all 750, 101, 105 series cars. Check the length of your old cable!
Layshaft intermediate bearing for 101 and 105 series gearboxes Also fits late 102 series and all 2600s (106 series).
Large rubber seal/gasket fitting between the transmission tunnel pressing and the transmission tunnel opening cover (metal or plastic/foam versions) on most 105 series. Suits Sprint GT, GTV, GTC...
error Your review appreciation cannot be sent