Pair of front brake calipers Alfa Romeo Montreal and Ferrari 308
Front brake calipers for the Alfa Romeo Montreal and Ferrari 308. Made in Italy, they replace the ATE calipers fitted as original equipment. Sold as a pair.
Active filters
Front brake calipers for the Alfa Romeo Montreal and Ferrari 308. Made in Italy, they replace the ATE calipers fitted as original equipment. Sold as a pair.
Ventilated rear brake disc for Alfa Montreal.
Ventilated front brake disc for Alfa Montreal.
Rear brake calipers for the Alfa Romeo Montreal. They are sold as a pair, one caliper for each side.
Pair of polyurethane axle bushes (diabolo type). Suitable for Alfa Romeo 105-115 series models from 1964 to 1993, as well as the Alfa Romeo Montreal. Sold as a pair; one pair is needed for the...
Pair of polyurethane washers for the reaction triangle (T-bar). Suitable for Alfa Romeo 105-115 series models from 1964 to 1993, as well as the Alfa Romeo Montreal. Sold as a pair; one pair is...
Kit of 4 upper polyurethane bushes for the front dampers of the Alfa Romeo GT Bertone, Giulia, Spider and Montreal. Each front damper takes 2 bushes, so a single kit is enough for the front axle.
Original-type rubber damper bush kit for Alfa Romeo 105-115 series and Montreal. The kit comprises 12 pieces: 4 upper bushes for the front dampers; 8 upper and lower bushes for the rear dampers....
Mounting nut used on the front suspension of Alfa Romeo 105-115 series cars from 1967 and the Montreal. It is used in two places: securing the 4 front wishbones to the crossmember bolts: 4 nuts...
Castellated stub axle nut for the front axle, with left-hand thread. Suitable for Alfa Romeo 105, 115, 750 and 101 series models, as well as the Alfa Romeo Montreal. Sold individually.
Castellated stub axle nut for the front axle, with right-hand thread. Suitable for Alfa Romeo 105, 115, 750 and 101 series models, as well as the Alfa Romeo Montreal. Sold individually.
Front and rear anti-roll bar set with a fast-road specification, for the Alfa Romeo Montreal. The set comprises: a 29 mm front bar, larger in diameter than the original bar; a thinner rear bar.
Set of 4 shorter, stiffer springs for the Alfa Romeo Montreal, taken from our complete handling kit (ref. MPI7225). They lower the car by about 50 mm and reduce body roll in corners. For good...
Inner track rod end - right-hand thread. Fits the centre link. Note that they also fit all 750 and 101 series cars on all steering joints.
Lowered and uprated fast-road suspension kit for the Alfa Romeo Montreal. The kit comprises: 4 short springs (lowering of approximately 30 mm); 2 anti-roll bars with their bushes: 29 mm front bar,...
Exhaust olive seal for the Alfa Romeo Montreal, fitted between the centre silencer and the rear silencer. Sold individually; the Montreal uses two per car. This seal also fits the Ferrari 400 and...
Rubber mount supporting the rear silencer of the exhaust system. It suits the Alfa Romeo GTV6 and Montreal, with one part required per car.
Complete exhaust system for the Alfa Romeo Montreal, excluding manifolds. The system comprises 6 components, sold together. Made in Italy.
Rear exhaust silencer (tail silencer) for the Alfa Romeo Montreal, left-hand side. The equivalent part for the right-hand side is reference MPI7532. Made in Italy. Sold individually.
Rear exhaust silencer (tail silencer) for the Alfa Romeo Montreal, right-hand side. The equivalent part for the left-hand side is reference MPI7217. Made in Italy. Sold individually.
Centre exhaust silencer for the Alfa Romeo Montreal, left-hand side. The equivalent part for the right-hand side is reference MPI7215. Made in Italy. Sold individually.
Centre exhaust silencer for the Alfa Romeo Montreal, right-hand side. The equivalent part for the left-hand side is reference MPI7532. Made in Italy. Sold individually.
Front exhaust silencer for the Alfa Romeo Montreal, left-hand side. The equivalent part for the right-hand side is reference MPI7536. Made in Italy. Sold individually.
Front exhaust silencer for the Alfa Romeo Montreal, right-hand side. The equivalent part for the left-hand side is reference MPI7100. Made in Italy. Sold individually.
Spica injection pump belt guard for the Alfa Romeo Montreal.
Plastic ball joint for the Alfa Romeo Montreal. It fits on the end of a rod in the injection pump control linkage. Sold individually.
Seal for the upper part of the fuel tank filler neck on the Alfa Romeo Montreal. Sold individually.
Medium (25-35 mm) stainless steel hose clamp/jubilee clip for general use on heater hoses, etc.
Stainless steel hose clamp/jubilee clip for general use on coolant hoses, etc.
Large (45-60 mm) stainless steel hose clamp to fit larger hoses such as the upper radiator hose at the inlet manifold joint on early 105 series cars.
Small (13-20 mm) stainless steel hose clamp/jubilee clip for general use on heater hoses, etc.
Water temperature gauge sender for the Alfa Romeo Montreal, located on the radiator. Check on the vehicle before ordering.
Fan belt for Montreal without power steering.
'U'-shaped coolant hose - runs between the cylinder heads on Montreal engines.
Set of 4 coolant hoses running from the radiator, for the Alfa Romeo Montreal. This set is for left-hand drive vehicles only. Please note: the hoses for right-hand drive versions are different and...
Ignition switch with steering lock for the Alfa Romeo Montreal. It is supplied with two keys. Sold individually.
Set of two contact breaker points for a Magneti Marelli distributor, intended in particular for the Alfa Romeo Montreal. The set comprises: one 3-spring contact breaker with long lead; one...
Distributor cap intended for the Alfa Romeo Montreal. It also suits Ferrari 308 models fitted with a single Magneti Marelli distributor cap. Sold individually.
Distributor rotor arm for the Alfa Romeo Montreal. It is also suitable for the Ferrari 308 fitted with a Marelli distributor. Sold individually.
Condenser for the Marelli twin-spark ignition system. Suitable for the Alfa Romeo GTA and Montreal. Sold individually: two are required per car.
NO LONGER AVAILABLE Complete ignition lead set for the left-hand drive (LHD) Alfa Romeo Montreal. It comprises 10 black ignition leads.
Complete set of red high-tension spark plug leads for the Alfa Romeo Montreal V8 engine.
Fuel filter for the Alfa Romeo Montreal. It fits inside the petrol tank, where it filters the fuel before it passes into the fuel supply system. Sold individually.
Main fuel filter, located in the engine bay, for all Alfa Romeo Montreals and all four-cylinder cars with Spica injection (US versions). Also available in the Montreal fuel filter set (ref. MN100).
Spica injection pump oil filter, Alfa Romeo Montreal
Set of three filters for the fuel supply system of the Alfa Romeo Montreal. The set comprises: the tank filter; the fuel filter located in the engine bay; the oil filter for the Spica injection...
Petrol pump (fuel pump) for the Alfa Romeo Montreal. It reproduces the external appearance of the original pump, preserving the look of the engine bay. Sold individually: the Montreal uses two per...
Pair of air filters to fit all Montreals. Perfect fit, made in Italy.
Water pump repair kit for the Alfa Romeo Montreal, comprising gaskets, bearings, washer and shaft.
Water pump gasket for the Alfa Romeo Montreal engine. Sold individually. This gasket is also offered as part of the repair kit, reference MPI7508.